T-N.T. H.L.R. Bucking | Heavy BB Design & Features
Tailored for Heavy BB Setups.
【H.L.R. Design Philosophy】
The H.L.R. bucking is designed around high rotational efficiency, stable pressure distribution, and long-range trajectory consistency, while also being optimized for setups requiring higher HOP efficiency and heavier BB configurations.
Compared to conventional HOP buckings, the H.L.R. places greater emphasis on BB contact consistency, spin generation efficiency, and overall shooting stability throughout the pressure cycle.
【Entry Ramp Design】
The H.L.R. features a larger R-angle entry ramp design, allowing the BB to enter the positioning area more smoothly during feeding while improving consistency of BB positioning.
A more stable BB starting position helps reduce minor deviation caused by inconsistent feeding impact, improving overall shooting consistency.
【Rearward Maximum Pressure Position】
The H.L.R. shifts the maximum HOP pressure point slightly rearward, allowing the BB to establish a more stable pressure state during travel.
As the BB approaches the exit area of the bucking, a more concentrated friction effect is generated, helping produce more stable rotational performance.
These characteristics become more noticeable when using heavier BB configurations.
【Rear Guide Ramp Design】
A secondary guide ramp is added behind the primary pressure area.
After the BB passes through the main HOP contact zone, the rear section continues providing directional guidance, helping maintain a more stable travel path.
This design helps reduce instability as the BB exits the primary pressure area, improving trajectory consistency and grouping performance.
【Reinforced Side Rib Structure】
The H.L.R. features reinforced side ribs around the pressure patch area to improve structural rigidity and support.
This helps reduce deformation and excessive expansion under HOP pressure, allowing the pressure surface to maintain more stable and complete contact with the BB.
This support characteristic becomes especially important under higher HOP pressure or heavier BB setups.
【Sandblasted Surface Treatment】
The internal contact surface of the H.L.R. bucking features a special sandblasted texture designed to increase friction characteristics.
This helps the BB generate more stable and consistent backspin while improving overall spin generation efficiency.